The Videofied™ Control Panel Model V7000 is an RSI VIDEO TECHNOLOGIES™ wireless, battery operated security system control panel.
The control panel is designed for residential, comercial and industrial security applications where video verification is needed or desired.
The control panel is powered by four 3.6-volt lithium batteries that can last at least four years, depending on the amount of system activity. A built-in siren provides status beeps and alarm sounds.
A dual-tamper function is active 24 hours, whether or not the system is armed. An alarm occurs if the control panel cover is removed, or if the control panel is removed from the mounting surface.
Supervised Wireless Technology
The V7000, along with all Videofied™ devices utilize patented S2View®—Spread Spectrum, Videofied™, Interactive, AES Encrypted Wireless technology, providing optimum signal integrity and security. Bi-directional RF communication paths between all system devices and the system control panel assure high signal reliability.
Radio jam detection identifies deliberate jamming of the system from outside parties. Integrated antennas eliminate protruding wires or rods that may be cumbersome when installing, are unsightly
to consumers, and if damaged could lead to potential system communication problems.
Supervision is accomplished by signal transmissions every eight minutes between each system device (excluding Keyfobs) and the control panel. These signal transmissions identify the unique identification code along with the current open/close state, tamper condition, serial number, manufacture date, software revision and battery status.
Power requirements Four 3.6 V batteries
Battery type Lithium, LSH20
Battery life 4 years
RF technology S2View®
Radio type Spread Spectrum Bidirectional RF
Operating frequency 915/868/920 MHz
Transmission security AES algorithm encryption
Radio jam detection Yes
Supervision polled signal every 8 minutes
Tamper detection Wall and cover tamper detection
Siren output 110 dB @ 1 meter
Siren duration 3 minutes maximum
Programming Alphanumeric Keypads or
Frontel remote control Software
Devices per system 25 maximum
Access codes 19 maximum
Installer codes One (for system programming only)
Security levels 3
Arming modes: 4
Areas 4 (Area 1 predefined from factory for
entry/exit delay. Areas 2, 3, & 4 programmable.)
Communicator formats Digital, voice, IP
Communicator type Analog phone line PTSN (TBR21)
Protocols Frontel, CID, SURTEC
IP stack IP, TCP/IP, HTTP, SMTP, PPP
Voice alarm transmission Up to 3 phone numbers
Voice server Pre-recorded messages
Email transmission Up to 2 Email addresses
Remote maintenance Frontel Downloader protocol only
VIdeo transmission: By Frontel protocol to
central monitoring station, or by Email.
Video format MPEG V1.0 video file
Video file size 220 Kbytes
Video framing 5 frames/second
Picture format JPEG
Picture size 320 x 240 pixels
History/Event Log 4,000 events stored in flash memory
Operating temperature 32° – 104° F (0° – +40° C)
Maximum relative humidity 70%, non-condensing
Approvals UL / FCC (V6000)
CE / EN50131 / EN300220 / INCERT/ IDA / NCP (VISIO1000)